Understanding the Network Segmentation and Its Types.

In this segment, we are going to understand the role of Segmentation in networking, how it works and more other concepts.

Segmentation is the way toward compartmentalizing a network system into smaller zones. This can take numerous structures, including physical, logical network systems, endpoints and many more.

Network System Segmentation

Both network system segmentation and design configuration are made out of physical and logical components. Any physical viewpoints are going to either require the use of hardware as of now or buying new devices (or both). Logical segmentation will require adequate information of your particular system, routing and design structure.

Physical Segmentation

Network system segmentation should begin, when conceivable with physical devices like firewalls and switches. Adequately, this transforms the network system into more manageable zones, which when structured appropriately can include a layer of protection against network interruption insider dangers and the spread of malicious software or activities.

Inside this visibility, a few favorable advantages are here:

1. The ability to monitor the traffic effectively with a packet monitor software.

2. More noteworthy investigating ability for network related issues.

Deliberately putting extra devices among the network system can enormously expand the accomplishment of segmentation. Statementing new devices from the production system should not only be a necessity expressed in strategy, yet additionally made to operate specialized controls. Demilitarized zone (DMZ) is the section of servers and devices between the production network and the internet or another bigger untrusted network. This section of devices will probably be under more serious risk of compromise as it is nearest to the internet.

Logical Segmentation

Logical network system segmentation can be effectively practiced with Virtual LANS (VLANS), Access Control Lists (ACLS), Network Access Controls (NAC) and an assortment of different technologies. When planning and executing controls, you should stick to following points:

1. Least privilege access should be included for the design structure at each layer as a top need and it fits well with the possibility of segmentation. If an outsider party needs access, guarantee that it’s access is limited to the devices that are required.

2. The firewall, switch, proxy and other different devices, as well as the guidelines and design configuration within those devices, should be efficient with regular naming conventions. Having sorted out setups likewise makes it simpler to investigate and remove them.

3. When configuring a firewall, the more specific the guidelines are, the more probable that only acceptable communication are allowed.   

4. Using host-based firewalls offers the chance to secure the particular destination and ports so that machines can not communicate on some port to any malicious machine.

5. All devices need not bother with access to the internet. Software can be installed from a local repository. Blocking internet access when it isn’t required will save time and pain.

VLANs (For Logical Segmentation)

A Virtual Area Network (VLAN) allows the design of distributed network connected devices to be on the same LAN using encrypted tunneling protocols.

The primary security defense by using VLANs is the internal security to the network system by conveying the packets just inside the destined VLANs when sending broadcasts. This makes it a lot harder to sniff the traffic over the network switches, as it will require an attacker to target a particular port, instead of capturing them all. Moreover, while using VLANS it is conceivable to make the division as per security approach and offer sensitive information just to clients on a given VLAN without presenting the data to the whole system. Other positive characteristics of VLAN are given below :

1. Networks are independent from the physical area of the devices.

2. Cost : Supplementing the network system by using VLANs and routers can diminish the expenditures.

There are a couple of various procedures that can be followed while customizing the way to deal with VLAN planning. One normal technique is to isolate endpoints into risk classes. When allocating VLANs based on risk class, the data that navigates  should also be classified. The lower risk class would include desktops, workstations, and printers, the medium-risk class would include servers and the high risk class would include domain controllers and PII servers. In a bigger network situation, this technique will make more sense and make a less complex network system plan.

ACLs (For Logical Segmentation)

A Network System Access Control List (ACL) is a channel or filter which can be applied to limit traffic between subnets or IP addresses firewalls,  mostly network routers. All information entering and leaving a section of a network system should be controlled. ACLs are applied to the network system to constrain as much traffic as could reasonably be expected.

NACs (For Logical Segmentation)

“Network Access Control (NAC) is a way to deal with network management and security that authorizes security approach, compliance and the management of access control to a network system.” NAC uses the 802.1X protocol, which provides validation at the port level, so devices are not connected with the system until authenticated.

The captive portals that prompt up after you’ve connected with the wireless signal at a railway station or airport are typically run by a NAC. They can isolate unknown and known devices onto their own VLANs or systems relying upon different classes.

VPNs (For Logical Segmentation)

A virtual private system (VPN) is a protected channel specifically created to send information over an open or less secure system using a strategy of encryption. VPNs can be used to segment sensitive information from an untrusted network, generally the internet.

Following these rules will guarantee a protected network setup:

1. Using the most robust possible authentication technique.

2. Using the most robust possible encryption technique.

3. Cutoff VPN access to those with a substantial business reason and only when necessary.

4. Give access to selected files through intranets or extranets instead of VPNs.

Two primary types of VPN design are used in big business environments: IPsec and SSL/TLS. Each has its advantages and security implications to think about.

Here are the upsides of an IPSec VPN: It is usually being used.

1. IPSec VPN is a customer based VPN that can be configured to connect with just websites and devices that can demonstrate their integrity: This gives the information that the devices interfacing with the system can be trusted.

2. IPSec VPNs are the favored selection of organizations for building up site-to-site VPN.

3. IPSec supports numerous techniques for verification and furthermore shows adaptability on picking the appropriate authentication component, along these lines making it hard for intruders to perform attacks like man-in-the-middle, and so forth.

Here are the upsides of SSL/TLS VPN

1. SSL/TLS VPNS take into account host integrity checking (the way toward evaluating associating devices against a security strategy, for example, the most recent OS version or OS fix status, if the antivirus definitions are up to date, and so on.)

2. They support numerous strategies for client verification and furthermore combination with centralized verification systems like Radius/LDAP, Active Directory, and so forth.

3. They permit the design of secure customized web-based interfaces for vendors or other clients to give restricted access to specific applications.

Final Words

Segmentation can pass over pretty much every part of a data security program, from physical to logical and regulatory to documentation. With each structure choice, just relax and sit back then take a look at the details.

More on Security Topics :

1. Ways To Prevent Identity Theft and Choose a Secure Password

2. Understanding Rootkits and How do they work ?

3. Understanding the Mostly Used Password Cracking Techniques

4. Understanding the Methodologies to Secure the Unix Application Servers

5. Understanding the Working of Viruses and Antiviruses 

Biplab Das

Biplab Das

My name is Biplab Das. I’m a writer, Blogger, Youtuber and full time IT support engineer whose childhood obsession with science fiction never quite faded. A quarter-century later, the technology that I coveted as a kid is woven into the fabric of everyday life. I’ve spent the past years to learn these technologies, I recently published a book on computer science fundamentals. People say smartphones are boring these days, but I think everyone is beginning to take this wonderful technology marvel for granted.
Keep Digging Technology.

Sign up for our Newsletter

Sign Up for our Newsletter for daily Updates !

shares